|
|
|
|
| 09:06 12/16/2008
|
| PENEPLUG |
 |
|
|
A cementitious, ready-mixed, rapid setting compound to stop water and moisture ingress.
RECOMMENDED FOR:
Concrete Masonry Earthenware Stone
PENEPLUG can be used internally or externally as waterproof plugging mortar or where rapid setting and early strength gain is required.
ADVANTAGES:
Stops water flow Sets in approx. 30 seconds after mixing Durable Can be used underwater Can be mixed with water or used dry Easy application Packaged in easy to use, resealable containers
TECHNICAL PROPERTIES:
Aggregate State: Powder
Color: Grey
Bulk Density: about 1.2 kg/l
Components: 1 component
Application temperature: +0 ?C to +25 ?C (allow for mixing water and substrate temperatures)
Application time: about 30 seconds (after mixing)
Shelf Life: 12 Months in unopened, undamaged bags
Packing: 18 kg 4 ply bags; 25 kg plastic resealable buckets.
SURFACE PREPARATION:
The substrate must be clean, sound and free of any surface contamination. Leaks must be cut out back to sound material, leaving an appropriate chase for receiving the PENEPLUG
MIXING:
Setting time is dependent largely on the amount of mixing water used. Standard value is (at 20 degrees C): 1 kg PENEPLUG and approx. 0.25 liter of water. The PENEPLUG must be added to the water and mixed swiftly. Mixing time is about 15 seconds. After mixing setting is in about 30 seconds.
In cold weather, use lukewarm water. In higher temperatures, use cold water.
To avoid wastage, only small quantities of PENEPLUG should be mixed.
APPLICATION PROCEDURES: After mixing, apply the PENEPLUG to the appropriate area immediately. Work the mixture well into the area and then hold firmly in place for about 30 seconds. (Wear rubber gloves). Maintain pressure without disturbing the material, until it has set. Remove excess material. After lightly prewetting apply a normal PENEPLUG waterproofing coating. In certain circumstance PENEPLUG may be applied as dry powder. Place and hold the power directly over the leak for 30-60 seconds.
NOTES: PENEPLUG contains cement. Avoid contact with skin and eyes. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Wear suitable gloves. Keep out of reach of children. For further information please refer to Material Safety Data Sheet.
WARRANTY:
ICS/Penetron International, Ltd. products will perform according to specifications only if directions are followed. ICS/Penetron International, Ltd. is not responsible for improper use, application, or storage of its products or for use of its products in unsafe weather or with unsafe engineering or working conditions. ICS/Penetron International, Ltd. products are supplied subject to standard terms and conditions of sale or rental, which limit ICS/Penetron International, Ltd. responsibility for the product. Any warranty of the product is limited to ICS/Penetron International, Ltd. unless otherwise specifically provided by ICS/Penetron International, Ltd. in writing. |
|
 |
|
|
