GLOSS PIGMENTED is a two component, 100 % solids, solvent-free epoxy coating. It is a high performance, tile-like coating used for coating steel tanks, pipes, castings, drums, wood, concrete and other masonry surfaces. Gloss Pigmented is particularly suitable for application with two-component
spray equipment. The coating is excellent for use on concrete block and similar surfaces. SURFACE PREPARATION: Prepare surface by method suitable for exposure and service. Always clean off any contamination between coats prior to applying subsequent topcoats. STEEL: All surface contamination, rust, mill scale, previous coatings, and any foreign matter must be removed by dry abrasive blasting to SA 2.5 ( near white metal ) and coated within 8 hours or before visible rusting occurs. Round off all rough welds and sharp edges and remove weld spatter. CONCRETE: New concrete must age 28 days before coating. Form release agents, curing compounds, salts, and previous coatings must be removed and surface properly prepared by mechanical abrasion, abrasive blast or acid etching. Surface must then be swept, vacuumed or flushed to remove all spent abrasives, dust and all other foreign matter. PRODUCT MIXING:
- Stir each component separately.
- Blend 1 part of Base to 1 part of Reactor by Volume and mix using a strong mixing stick or slow speed drill equipped with a paint propeller.
APPLICATION: Apply mixed material by brush, roller or sqeegee. Apply second coat if needed after first coat has cured overnight. Gloss Pigmented can be applied as thick as desired without affecting the cure. For a non-skid surface, sand can be broadcast on the first coat while still wet. Apply second coat if needed. CHEMICAL RESISTANCE: Resistant to mild mineral acids, alkalies, detergents, solvents, skydrol, hydraulic fluids, lubricating oils, deicing salts, etc. LIMITATIONS: Do not apply at temperatures below 50 degrees F. Mix only amount that can be applied in 45 minutes. PACKAGING: Standard Packaging : 1 Gallon Part A : 1 Gallon Part B in a carton.
Available :1/2 gallon units, 10 Gallon units WARRANTY:
ICS/Penetron International, Ltd. products will perform according to specifications only if directions are followed. ICS/Penetron International Ltd., is not responsible for improper use, application, or storage of its products or for use of its products in unsafe weather or with unsafe engineering or working conditions. ICS/Penetron International, Ltd., products are supplied subject to ICS/Penetron International, Ltd.'s standard terms and conditions of sale or rental, which limit ICS/Penetron International, Ltd's responsibility for the product. Any warranty of the product is limited to ICS/Penetron International, Ltd.'s or the manufacturer's standard warranty unless otherwise specifically provided by
ICS/Penetron International, Ltd. in writing.
|
